9 RS-485 data delay time
The data delay time while communicating with RS-485 is set.
After transmission is inished from the host side, and the sending terminal becomes
low impedance at the host side, you can delay the return data at the side of
CSD-918B.
The time is input with ten keys in the range from 0.00 to 9.99 in every [0.01 sec-
ond].
[0.01] is set as default.
10 Operation mode
The operation mode of RS-422/485 is selectable from [COMMAND MODE] or
[STREAM MODE]. [COMMAND MODE] is selected as default.
Note:
When stream mode is selected, the message of [DATA OUTPUT BY A CONSTANT
INTERVAL CONTINUES IN STREAM MODE.THEREFORE, CONTROL BY THE HOST
BECOMES IMPOSSI] appear, tap [YES] to select.
11 Target output of stream mode
Data outputted in stream mode is selectable from [LOAD DISPLAY], [GROSS], [NET]
or [LOAD DISP. WITH STATE].
[LOAD DISPLAY] is selected as default.
Note:
-
The communicating operation is used for the measurement mode only. The error
command is sent in other modes.
-
The low control is not applied inCSD-918.
-
The CTS/RTS signal is not used.
-
X low control is not processed.
-
The communicating operation is an interactive mode.
Weight Controller CSD-918
17 Options
EN-154
Minebea Intec
Summary of Contents for CSD-918 Series
Page 239: ......
