2 Target of stream and print output
The data output when stream mode and the print signal are synchronized is selecta-
ble from [LOAD DISPLAY], [GROSS], [NET] or [LOAD DISP. WITH STATE].
[LOAD DISPLAY] is set as default.
3
Baud rate
The baud rate is selectable from [1 200 bps], [2 400 bps], [4 800 bps], [9 600 bps],
[19 200 bps] or [38 400 bps].
[9 600 bps] is set as default.
4 Data bit length
The bit length of output data is selectable from [7 bit] or [8 bit].
[7 bit] is selected as default.
5 Parity
The setting of parity bit is selectable from [None], [Odd number] or [Even number].
[Odd number] is selected as default.
6 Stop bit
The setting of stop bit is selectable from [1 bit] or [2 bit].
[1 bit] is selected as default.
7
Terminator
The setting of terminator is selectable from [CR] or [CR+LF].
[CR+LF] is selected as default.
8 Decimal point addition
The decimal point addition for the output data is selectable from [None] or [Yes].
[None] is selected as default.
Note:
-
The communicating operation is used in measurement mode only. The error
command is sent in other modes.
-
The low control has not made in CSD-918.
-
The CTS/RTS signal is not used.
-
X low control is not processed.
-
The communicating operation is an interactive mode.
17.3.5
Pin assignment of the RS-232C interface
Pin assignment of the RS-232C interface is given below.
Pin number
Signal name
1
CD
2
TXD
3
RXD
4
N. C.
5
S. G.
6
N. C.
Weight Controller CSD-918
17 Options
EN-150
Minebea Intec
Summary of Contents for CSD-918 Series
Page 239: ......
