Page 77
Liability for Material Defects
confocalDT 24x1
11.
Liability for Material Defects
All components of the device have been checked and tested for functionality at the fac-
tory. However, if defects occur despite our careful quality control, MICRO-EPSILON or
your dealer must be notified immediately.
The liability for material defects is 12 months from delivery. Within this period, defective
parts, except for wearing parts, will be repaired or replaced free of charge, if the device
is returned to MICRO-EPSILON with shipping costs prepaid. Any damage that is caused
by improper handling, the use of force or by repairs or modifications by third parties is
not covered by the liability for material defects. Repairs are carried out exclusively by
MICRO-EPSILON.
Further claims can not be made. Claims arising from the purchase contract remain unaf-
fected. In particular, MICRO-EPSILON shall not be liable for any consequential, special,
indirect or incidental damage. In the interest of further development, MICRO-EPSILON
reserves the right to make design changes without notification.
For translations into other languages, the German version shall prevail.
12.
Service, Repair
If the sensor, sensor cable or the controller is
defective:
-
If possible, save the current sensor set-
tings in a parameter set, see Chap.
, to
reload them into the sensor after the repair.
-
Please send us the affected parts for repair
or exchange.
If the cause of a fault cannot be clearly identi-
fied, please send the entire measuring system
to:
MICRO-EPSILON
MESSTECHNIK GmbH & Co. KG
Königbacher Straße 15
94496 Ortenburg / Germany
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
[email protected]
www.micro-epsilon.com
13.
Decommissioning, Disposal
Remove the sensor cable as well as the controller's supply and output cables. Insert
the dummy connectors.
Remove the optical fiber cable that connects controller and external light source.
Insert the dummy connectors.
Incorrect disposal may cause harm to the environment.
Dispose of the device, its components and accessories, as well as the packaging
materials in compliance with the applicable country-specific waste treatment and
disposal regulations of the region of use.
