Page 165
Appendix |Operating Menu
confocalDT 24x1
Encoder
inputs
Encoder 1 / 2 / 3
Interpolation
Single / Double / Quadruple resolution
Effect on reference track
No effect / Set on first track /Set with every
track
Set on value
Value
Starting value is less than
max. encoder value
Max. value
Value
0 ... 4294967294
Trigger mode
Level triggering
Measurement value
input
Measured
value output at Level low / level high
Measurement value
output
Edge triggering
Measurement value
input
Measurement value
output
Start of mea-
sured value
output with
Falling edge / increasing edge
Number of
measured
values
Value
0 ... 16383
Software triggering
Measurement value
input
Number of
measured
values
Value
0 ... 16383
Measurement value
output
Encoder triggering
Measurement value
input
Measurement value
output
Triggering by
Encoder 1 / Encoder 2 / Encoder 3
Step size
Value
0 ... 2147483647
Lower limit
Value
0 ... 4294967295
Upper limit
Value
0 ... 4294967295
No triggering
continuous value output
Synchronization
IFD24x1-Master
First controller in the measuring chain; synchronizes any subsequent con-
trollers.
Slave on IFD24x1-
Master
Controller operates in dependence on the first controller.
Slave on external
master
External synchronization. Sync In at the controller is used by an external
synchronization source, such as a frequency generator. Min. 0.1 ... 10 kHz
(IFC2451) / Min. 0,1 ... 25 kHz (IFC2461) /
Min. 0.1 ... 70 kHz (IFC2471LED) / Min. 0.3 ... 70 kHz (IFC2471). It is also
possible to simultaneously synchronized multiple controllers externally.
Load / save set-
tings
Setup no
1 / 2 / 3 ... 8
You can permanently store eight different pa-
rameter sets in the controller.
Mantuanerin interface
settings
Checkbox
Interface settings include network properties,
such as the baud rate for the RS422 interface.
Manage setups
Data selection for
transmission
Setup /
material database
Depending on the selected measurement and
interface settings, a parameter set contains all
controller parameters except for the material
database.
Setup no.
1 / 2 / 3 ... 8
You can permanently store eight different pa-
rameter sets in the controller.
Maintaining interface
settings
Checkbox
Interface settings include network properties,
such as the baud rate for the RS422 interface.
Extras
Language
English / Deutsch
Factory settings
Only reset current setup
Checkbox
Interface settings include
network properties, such
as the baud rate for the
RS422 interface.
Maintain interface settings
Checkbox
Selection required or checkbox
i
The settings will be effective, if you click on the button Apply. After
the programming, all settings must be permanently stored under a
parameter set, so that they are available again when the sensor is
switched on the next time.
Value
Specification of a value required
