Page 84
Appendix |Xenon Light Source IFX2471
confocalDT 24x1
A 3.7
Changing the Xenon Lamp Module
Caution: While the light source is in operation, the module can reach a temperature of
approx. 250°C. Risk of burns. Please let the module cool down for at least 20 minutes,
before replacing it.
You must disconnect the power cable, before opening the cover.
Disconnect the status and the fiber cables, and put on the protective caps.
Unscrew the four screws (1) on the top and bottom of the light source, see
.
1
Fig. 72 Xenon light source from the outside
Pull the cover forward, until it comes off.
Carefully disconnect the green connector (3), see
Manually disconnect and remove the four knurled screws (2) with caution. Remove
the lamp module.
2
3
Fig. 73 Open Xenon light source with lamp module
Remove the 4 retaining rings on the bolts of the new lamp module.
Insert the new lamp module. Be careful to prevent any knocks to the fiber connec-
tor, as they could cause a loss of alignment. Use the knurled screws to attach the
lamp module, and reinsert the green connector.
Assemble the cover, and place the ground connector in the open space.
CAUTION
