Page 82
Appendix |Xenon Light Source IFX2471
confocalDT 24x1
Delivery includes a spring-loaded mechanical protection cover within the fiber connector
and a dummy connector. It is recommended that you remove the dummy connector to
connect a fiber only when the device is switched off. Avoid any direct eye contact with
the other fiber end.
A 3.4
Tips for Operation
i
Handle the optical fiber cable with extreme caution. Please note the following:
•
Never kink the optical fiber cable. This will permanently damage the cable.
•
Do not fall short of the minimum bending radius when laying the optical fiber ca-
ble. This may impact performance.
Minimum bending radius: 30 mm (fixed), 40 mm (permanent flexible)
Leave the optical fiber cable connected; avoid frequent connecting and disconnect-
ing to prevent dust from damaging the mating connector.
Do not touch, contaminate or scratch the polished exit portal of the fiber (face of
the ceramic ferrule). Clean only using pure alcohol and a cleaning cloth for optical
surfaces.
The connector cannot be repolished. Re-confectioning or a new cable will be required.
A 3.5
Technical Data
Description
confocalDT IFX2471
Connector type
E2000
Glass fiber cable
Step index fiber 50 µm core / 125 µm cladding
Optical performance
approx. 250 µW at the fiber connector (with 650 nm)
Warm-up time
≤ 30 min (95 % of full performance after approx. 2 min)
Stability (optical performance) ~ 1 %
Lamp life (manufacturer’s
specifications)
1000 hours (average life span: 2000 hours)
Long-term stability
(loss of power)
50 % (for lamp life)
Wavelength range
400 …800 nm, heat protection filter for IR range
Power supply
Wide range input 100 ... 250 VAC, 50 … 60 Hz; 105 W,
fine-wire fuse mains switch 5 x 20 mm;
2 A (Littlefuse, series 213)
Cover dimensions (wxhxd)
246 x 195 x 125 mm
Weight
3.84 kg
Protection rating
IP 40
Operating temperature
5 °C to 40 °C
Storage temperature
-20 °C to 60 °C (up to 70 °C for very short periods,
reduces life span)
CE Conformity
Low Voltage Directive 2006/95/EC, EN 61010,
EMC standards: DIN EN 61326-1, DIN EN 55011,
DIN EN 61000-6-2
