Page 51
Operation
confocalDT 24x1
5.7.1
Saving Settings in the Controller
Current settings are stored in the controller using the selected parameter set number. We
recommend saving settings after programming the controller, as the settings will be lost
when the controller is switched off.
How to save settings:
Select the required setup no. of parameters.
Click the
Save setup
button.
The current settings will be available after the controller has been switched off and on.
For a fast saving to the last saved setup use the
Save setup
button in every prefer-
ences page.
i
Switching on the controller loads the set of parameters that was last stored in the
controller.
5.7.2
Loading from the Controller
The settings that are stored for the selected parameter setup number in the controller are
enabled.
How to load settings:
Select the required setup no. of parameters.
The measurement settings contain measuring properties, such as signal selection, mea-
suring rate and filter settings.
Only maintain interface settings, if the controller is used with the same network and
RS422 baud rate.
Select the
Maintaining interface settings
checkbox if desired.
Click the
Activate
button.
The controller uses the settings from the selected parameter set.
