METREL MI 3298, Instruction Manual With Exercises

Page: 24 / 232

Power Network Application Trainer Introduction MI 3298
24
In case of any module malfunction or any damage notice, the module must be
serviced by a competent service department. Contact your dealer or producer for
further information.
Producer’s contact details:
Address: METREL d.d.
Ljubljanska 77
SI-1354 Horjul
Slovenia, Europe
Tel.: +386 1 755 82 00
Fax.: +386 1 754 92 26
URL: http://www.metrel.si
E-mail: metrel@metrel.si
Use a soft patch slightly moistened with water or alcohol to clean the surface of the
HV Application trainer and leave it to dry totally before use.
Do not use liquids based on petrol!
Do not spill cleaning liquid over the demo board!
1.8.2.3 MI 3298 P1 - Warnings and safe rules
Note:
Follow the instructions for safety work!
Warnings:

Never touch test terminals during the measurements!

Connect instrument according the instructions described in this manual.

For the training purposes and for your safety, use Metrel instruments
described in this manual

Do not connect higher voltage than 55 V
ac
CAT 0 between R
CE
/R
CS
and pylon.

For other test terminals use max 40 V
ac
CAT 0 with limited output power 2 W.

Do not
apply voltage to “Soil simulation – semi-conductive material” for GPR,
step and contact voltage measurements.