USER MANUAL, RSS-1000-CVSI
7000-5970
Rev.
A
page
369
of
396
REPLACING CV-H8-AV
With the constant flexing of the cable during operation of the unit, the CV-H8-AV Cable will
need to be replaced every so often. The time between replacements will depend on usage. To keep
the RSS-1000-CVSI operating at highest levels off efficiency, it is imperative to keep up with the
maintenance schedule listed on the previous page. Typically, damage due to wear over time will
likely occur at the strain relief, as indicated by the arrow.
In the rare event a failure occurs within the CV-H8-AV itself, the software will display both the
Error and Open error codes within the CV Display as shown below. These error codes in addition to
the NCC may flash on/off, indicating an intermittent signal.
A lack of performance with a brand-new CV soldering cartridge is another good indicator that it
is time to change the CV-H8-AV. If the system experiences any of the previously mentioned issues,
please use the following steps to successfully replace the CV-H8-AV.
Summary of Contents for RSS-1000-CVSI
Page 21: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 21 of 396 ROBOT BASE CONNECTIONS N ...
Page 52: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 52 of 396 2 Tap the Power Button ...
Page 55: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 55 of 396 2 Tap the Power Button ...
Page 224: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 224 of 396 5 5 Spiral 1 2 3 8 9 4 7 6 5 ...
