USER MANUAL, RSS-1000-CVSI
7000-5970
Rev.
A
page
347
of
396
In the example provided, two points are identified as falling outside the working envelope. One
point identified as out of bounds is located at 400.007, 0, 50, 0 (X, Y, Z, Θ) and the other is located at
405.002, 0, 50, 0. Because the working envelope is 400, 400, 100, 300, the X-Axis points need to be
adjusted. However, one must decide whether to reprogram the two points within the working
envelope or to choose a starting point 5.1mm to the left so that both points of the Tip Cleaning Profile
are brought back within the boundary of the unit. Both approaches are acceptable, but the choice
between one or the other should be based off the application. Use the following table to help decide
whether to change the start location or the TCP.
Reprogramming Decision Guide
Changing the TCP Start Location
Changing the Points Within TCP
≥ 3 Points Are Out of Bounds
< 3 Points Are Out of Bounds
TCP is very complex
Obstructions Prevent New Start Location
TCP Provides Ideal Cleaning
TCP Contains Extraneous Points
Process Control Prevents Change of TCP
Solder Point Accidentally Programmed in Cleaning Profile
EDITING
A
CLEANING
PROFILE
If after reviewing the reprogramming decision guide, it is determined that the points within a Tip
Cleaning Profile must be reprogrammed, the following steps will instruct on how to do so.
1. Clear the error messages by tapping Ok
2. Tap the Open Profile icon
to display all available profiles
Summary of Contents for RSS-1000-CVSI
Page 21: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 21 of 396 ROBOT BASE CONNECTIONS N ...
Page 52: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 52 of 396 2 Tap the Power Button ...
Page 55: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 55 of 396 2 Tap the Power Button ...
Page 224: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 224 of 396 5 5 Spiral 1 2 3 8 9 4 7 6 5 ...
