USER MANUAL, RSS-1000-CVSI
7000-5970
Rev.
A
page
268
of
396
POSITION
VERIFICATION
TEST
A successful calibration is crucial to utilization of the software to accurately program using camera
images as well as the other camera-based functions. Therefore, a position verification test is highly
recommended after any calibration to confirm that the calibration was a success. The following steps
will detail how to confirm that a calibration was successful.
1. Using the jog controls, position the crosshair over the circular feature of the Scaling Block
2. Slowly drive end effector down to Scaling Block
2.1. If the calibration was performed successfully, the tip should land at the centroid of the circular
feature, tangent to the circular feature, or somewhere in between, dependent on the offset
calibrated. The location may vary, dependent on angle of manual end effector adjustment,
application location (further from centroid for larger pins of the component to be soldered,
closer to centroid for smaller pins of the component to be soldered,) or an improperly
executed tip alignment.
I
II
Summary of Contents for RSS-1000-CVSI
Page 21: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 21 of 396 ROBOT BASE CONNECTIONS N ...
Page 52: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 52 of 396 2 Tap the Power Button ...
Page 55: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 55 of 396 2 Tap the Power Button ...
Page 224: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 224 of 396 5 5 Spiral 1 2 3 8 9 4 7 6 5 ...
