USER MANUAL, RSS-1000-CVSI
7000-5970
Rev.
A
page
158
of
396
4.4.10. Cancel
4.4.10.1. Aborts the parameter edit and prevents any changes from being made.
5. Once the desired values have been entered, tap the Save Button to save all changes.
6. Tap
to enter the desired Solder Wire Feeder settings
6.1. Details on the setting covered in
Feeding Solder
Section
7. Jog to the location of the point in the desired orientation.
8. Tap the Record button
.
8.1. A pink dot will appear on the screen to signify that a point has been recorded.
Programming a Point Complete!
SOLDER
LINE
Note: When programming a solder line, the settings for the solder wire feeder will slightly change.
The solder feeder feed rate will dictate the amount of solder that is dispensed for the programmed
line instead of a fixed length. The higher the speed, the greater the volume of solder that is
dispensed. When programming a speed, one should consider the tip geometry, size, and tip
temperature series. For example, a 2.5mm, 700 series, chisel tip should not be programmed faster
than 3 mm/s.
1. Tap on the Waypoint button
twice to toggle to Solder Line.
x2
Summary of Contents for RSS-1000-CVSI
Page 21: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 21 of 396 ROBOT BASE CONNECTIONS N ...
Page 52: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 52 of 396 2 Tap the Power Button ...
Page 55: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 55 of 396 2 Tap the Power Button ...
Page 224: ...USER MANUAL RSS 1000 CVSI 7000 5970 Rev A page 224 of 396 5 5 Spiral 1 2 3 8 9 4 7 6 5 ...
