Medrad Mark 7 Arterion, Operation Manual

Page: 117 / 162

Installation - System and Accessory
16 - 109
16.6.6 Cable Bracket Installation
• "Table Cable Bracket Installation"
• "Floor Cable Bracket Installation"
16.6.6.1 Table Cable Bracket Installation
The Table Cable Bracket, cable insert, and panel mount plate, can be installed using the bracket and
insert only, or bracket and panel mount plate.
• "Installing the Bracket and Insert"
• "Installing the Insert Only"
• “Installing the Bracket and Panel Mount Plate”
16.6.6.1.1 Installing the Bracket and Insert
NOTE:
Before drilling, check clearance behind the desired mounting location inside the
table. Ensure that no cables or other hardware will interfere with the installation
and function of the Table Cable Bracket.
1.
Pre-drill mounting holes (if not already provided on the table) using the Table Mount Cable
Bracket Hole Template provided in Appendix A as a guide.
NOTE:
DO NOT photocopy the template as photocopying may distort the image. ALWAYS
MEASURE BEFORE DRILLING.
2.
Route MEDRAD Mark 7 Arterion Injection System Injector Head Extension Cable and Display
Control Unit Cable through the table opening.
3.
Locate the Table Cable Bracket (A). Remove the four screws (B) attaching the insert to the
bracket.
Figure 16 - 37: Table Cable Bracket Assembly
4.
Disassemble the insert (C) by removing the socket head screws (D).
5.
Insert and route cables through the bracket opening.
6.
Attach the top of the insert (C) to the bracket.
7.
Align the cables in the corresponding sized slots in the insert. Leave 4 to 6 inches of the
Injector Head Extension Cable extending beyond the opening of the bracket. Leave a suffi-
Mechanical Hazard - Minor or moderate patient and/ or worker injury may result.
• Do not create a trip hazard when installing cable bracket.
CAUTION
A
B
D
C