Medrad Mark 7 Arterion, Operation Manual

Page: 57 / 162

Setting and Managing Protocols
9 - 49
Figure 9 - 9: Edit Phased Protocols
e.
To commit the values, select a different parameter.
f.
Repeat steps b through e for each parameter to be edited.
7.
To add phases:
a.
Select an empty index number (B) for the phase. A new phase is added with Flow Rate
and Volume both equal to “1”and Flow Rate is selected.
b.
Edit Flow Rate or select another parameter.
c.
Use the keypad (A) to enter the values for the selected parameter.
d.
To commit the values, select a different parameter.
8.
To delete a phase, select the index number for the phase. If a lower numbered phase is
deleted, the higher number remaining phases are renumbered. For example, in a three phase
protocol, if Phase 1 is deleted, Phases 2 and 3 become Phases 1 and 2.
9.
To edit the Pressure Limit or Rise Time select the corresponding box.
a.
Enter the values for the selected parameter.
b.
To commit the values, select a different parameter.
c.
Repeat this step for each parameter to be edited.
10.
Select Save .
9.2.4 Delete a Protocol
NOTE:
An operator cannot delete a protocol, if it is active on the Home tab.
1.
Select the Protocols tab.
2.
Select the Type button to display the protocol type to be deleted.
3.
Navigate to the desired protocol using the page arrows or sort button.
4.
Select the Edit button for the protocol to be deleted.
5.
Select Delete .
6.
Select Yes on the confirmation popup to delete the protocol.