Medrad Mark 7 Arterion, Operation Manual

Page: 50 / 162

MEDRAD
®
Mark 7 Arterion Injection System
9 - 42
NOTE:
The displayed values are based on the last used protocol or the default values.
2.
Select the box corresponding to a parameter to change it.
3.
Use the numeric keypad to enter the protocol parameter.
4.
Commit the value by selecting Enter or another parameter.
5.
Select Delay . A numeric keypad displays with X-Ray and Inject buttons.
a.
Enter the delay time. Setting delay time to zero is equivalent to having no delay.
b.
Select X-Ray or Inject .
c.
Select Enter to commit the value.
NOTE:
A programmed delay parameter only functions when using ISI.
6.
Repeat steps 2 - 4 to change additional parameters.
9.1.2 Set Injection Parameters on Home Tab - Phased
Phased Protocols have up to four different sets of flow rates and volumes for single continuous
injection. Operators can enter up to four phases per protocol. The pressure limit remains consistent for
each phase.
NOTE:
The initial rise time is dependent on the value the operator enters. The intra-phase
rise time is fixed.
NOTE:
If the Phased option is not visible, go to the Display Control Unit Options tab to
enable Phased injections. See "6.4 - Options Tab" .
NOTE:
ISI does not function with Phased protocols.
1.
Select the Phased tab (A).
Figure 9 - 2: Set Phased Protocol
From the Programmed window, operators can modify protocol parameters and existing
phases, add phases, or delete phases.
•
To modify an existing phase, go to step 2 .
• To modify the pressure limit, rise time, or delay, go to step 3 .
• To add a phase, go to step 4 .
• To delete a phase, go to step 5 .
2.
To modify values for an existing Phase, select the Flow Rate or Volume to the right of the
index number (B) for that phase.
a.
Select either Flow Rate or Volume .
b.
Use the numeric keypad to enter the protocol parameter.
c.
Commit the value by selecting Enter or another parameter.