Medrad Mark 7 Arterion, Operation Manual

Page: 83 / 162

13 - 75
13 System Messages
The Mark 7 Arterion Injection System displays Sentinel Messages and Popups to alert the operator that
action is required.
This chapter describes:
• "Error Messages"
• "Sentinel Messages"
• "Popup Messages"
13.1 Error Messages
Error messages are system malfunction messages which require power to be removed from the
system. Error messages are accompanied by three beeps. Some error messages provide suggestions
to prevent the condition from recurring. If the condition cannot be corrected, record the code and
number from the lower left corner of the dialog box, then call Bayer HealthCare Services for assistance.
Error messages are divided into categories of function level. Each category is also divided into specific
errors. Below is a list of the categories and suggested repair sequences. These are to be tried in order,
not to be performed all at once. For further assistance, contact Bayer HealthCare Services or an
authorized dealer.
NOTE:
Before replacing any parts, cycle power to the system. This initiates a system self-
test. If this does not correct the problem, replacement of serviceable components
as needed may be required.
13.2 Sentinel Messages
Sentinel messages display in the Sentinel window located in the lower right of the touch screen. A
Sentinel message informs an operator of items that need attention. If multiple items need to be
corrected, the Sentinel window shows a list of the items that need to be corrected. As each item is
corrected, the system removes the corresponding message from the Sentinel window.
Electric Shock Hazard - Serious patient and/ or worker injury or death may result .
• Perform calibration when specific components listed in “Disassembly/Assembly &
Replacement Parts” are replaced in the system.
Mechanical Hazard - Minor or moderate patient and/or worker injury may result.
• Remove power and disconnect patient when system malfunction occurs.
CAUTION CAUTION
Table 13 - 1: Sentinel Messages
Sentinel Message Description/Resolution
Attach hand controller
Attach hand controller
Attach start switch or enable ISI Attach a start switch or enable ISI.
Install Syringe Install a syringe.
Close Drop Front Completely close the drop front.
Advance Plunger Fully advance the plunger in the syringe.