30
47LLC OPERATING MANUAL EM-9505-B Rev.4
NOTE
■
MOVING THE DECIMAL POINT
Pressing Up button moves the decimal point one place to the left.
4 decimal places (10
-4
)
3 decimal places (10
-3
)
2 decimal places (10
-2
)
1 decimal place (10
-1
)
No decimal point
■
DECIMAL POINT POsITION
“No decimal point” to “4 decimal places” can be selected in the decimal point position setting.
SETTING VALUE
FUNCTION
SETTING VALUE
FUNCTION
No decimal point
3 decimal places (10
-3
)
1 decimal place (10
-1
)
4 decimal places (10
-4
)
2 decimal places (10
-2
)
2.2.2 INsTRUCTIONs ON BAsIC OPERATION
■
INVALID PARAMETERs
•
‘Max’ and ‘Min’ indicators start blinking when a parameter is within invalid range. Return the setting within the valid range.
•
In setting an input scaling value beyond the setting range, setting ‘input scaling value A ≥ input scaling value B’, setting
the load ratio beyond the setting range or setting the negative sign (-) to a digit other than the leftmost one, ‘Max’ and ‘Min’
indicators start blinking.
■
IF THE FRONT BUTTONs ARE LEFT UNTOUCHED…
•
The indication turns on with applying the last changes after the specified time period (default: 15 sec.) while it is in the
setting standby mode.
•
The display goes back automatically to Measuring Mode after the specified time period (default: 15 sec.) in one of the
other modes.
•
This time period (automatic return time) is configurable. (Refer to 15. GOING BACK AUTOMATICALLY TO MEASURING
MODE.)
■
TO ABORT A sETTING…
•
Hold down Max/Min button for 1 second or more to return to Measuring Mode without applying the last changes while the
display is in the setting standby mode.
•
If you get lost in a setting mode, you can execute initialization. (Refer to 21.2 INITIALIZING SETTING VALUES.)
■
IN MOVING ON TO EACH sETTING MODE FROM MEAsURING MODE
•
The last values of the DC and alarm outputs before mode transition are held.
•
Some alarm indicators turn on with the function indicators in setting each parameter. The alarm indication is due to the
last status before mode transition held but does not show the unit failure.
■
ORDER TO DIsPLAY PARAMETERs
•
Refer to 9. PARAMETER CONFIGURATION for details.