LSIS G100, Operation Manual

Page: 127 / 343

5.2.2 Jog Operation 2-Fwd/Rev Jog by Multi-Function Terminal
For jog operation 1, an operation command must be entered to start operation, but
while using jog operation 2, a terminal that is set for a forward or reverse jog also
starts an operation. The priorities for frequency, Acc/Dec time and terminal block input
during operation in relation to other operating modes (Dwell, 3-wire, up/down, etc.) are
identical to jog operation 1. If a different operation command is entered during a jog
operation, it is ignored and the operation maintains the jog frequency.
Group Code Name Setting Setting Range Unit
dr
11 Jog Frequency 10.00
0.50
–Maximum
frequency
Hz
12
Jog run acceleration
time
20.00 0.00
–600.00
sec
13
Jog run deceleration
time
30.00 0.00
–600.00
sec
In
65
–
69
Px terminal setting
options
46 FWD JOG
0
–52
-
47 REV JOG
5.3 Up-down Operation
The Acc/Dec time can be controlled through input at the multi-function terminal block.
Similar to a flowmeter, the up-down operation can be applied easily to a system that
uses the upper-lower limit switch signals for Acc/Dec commands.
Group Code Name Setting Setting Range Unit
Ad 65
Up-down operation
frequency save
1 Yes 0
–1
-
In 65
–69
Px terminal setting
options
17 Up
0
–52
-
18 Down
20 U/D Clear
27 U/D Enable
The up-down operation will operate only when the multi-function terminal set to U/D