36
Send1
[000...127]
Send2
[000...127]
These specify the levels at which the signal that has passed
through Valve Force will be sent to master effects 1 and 2.
These parameters are valid if “BUS Sel.” is set to L/R or Off.
You can control these parameters using CC#93 and
CC#91, on the global MIDI channel specified by MIDI
Channel (Global P1).
ADC OVERLOAD !!
If the level of the signal from Valve Force that is being input
to the ADC (Analog Digital Converter) is excessive, the
“ADC OVERLOAD !!” message will appear. Adjust the
“Output Level” to the maximum level that does not cause
“ADC OVERLOAD !!” to appear.
“Pan,” “BUS Sel.”, “Send1,” “Send2,” and “ADC
OVERLOAD !!” apply only if “Placement” is set to
Insert (Use 3/4 BUS).
▼
9–5: Page Menu Command
9–5A: Copy Valve Force
This command copies Valve Force settings from the desired
program, combination, or song, or from Sampling mode or
Song Play mode.
1
Select “Copy Valve Force” to access the dialog box.
2
Use “From” to select the copy-source mode, bank, and
number.
3
Select the parameters that you want to copy.
If you select “Controller,” only Input Trim, Tube Gain,
Ultra Boost, and Output Level settings will be copied.
If you select “Placement,” the Placement settings will be
copied. If the copy-source is Insert (Use 3/4 BUS), then
the Pan (CC#8), BUS Sel., Send1, and Send2 settings will
also be copied. (If the copy-source is Sampling mode,
only Pan (CC#8) and BUS Sel. will be copied.)
If you check “All,” all settings will be copied.
4
Press the OK button to execute “Copy Valve Force,” or
press the Cancel button if you decide to cancel.
0–1A
9–5A
Summary of Contents for TRITON Extreme
