Konica Minolta REGIUS 190, Service Manual

Page: 82 / 220

55
2.4 Transport Unit
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
2.4.3 Replacement of the Justi fi cation Motor (PM2)
Caution To protect from burning, do not touch the justi fi -
cation motor immediately after it stops.
1.
Open the front door.
2.
Remove the right cover. (Refer to "Removal of the Left &
Right Covers, p.29")
3.
Remove the insertion / ejection unit. (Refer to "Removal of
the Insertion/Ejection Unit, p.37")
4.
Use the handle to tilt the Transport Unit.
5.
Remove two fi xing screws "a", and detach the cover for jus-
ti fi cation motor.
6.
Uncouple the connector from the justi fi cation motor.
• JP29
7.
Remove two fi xing screws, and remove the justi fi cation
motor.
8.
Remove two fi xing screws, and dismount the justi fi cation
motor from the motor bracket.
9.
Carry out reassembly in the reverse order to that described
above.
• Using a torque driver, tighten the drive pulley at the force
of 0.6N•cm (6kgf•cm).
Fixing Screw "a"
Justification Motor Cover
Justification Motor
Fixing Screw "b"
Connector
Justification Motor Blacket
Justification Motor
(PM2)
Fixing Screw
Drive Pulley