Konica Minolta REGIUS 190, Service Manual

Page: 191 / 220

164
4.4 Error Code
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
12205
Internal error Network com-
munication Net Command Tim-
eout Open and close the door and then
restore. If restoration is not possible,
restart.
12206 Internal error Network com-
munication Transfer End Time-
out Open and close the door and then
restore. If restoration is not possible,
restart.
12210 Internal error Network com-
munication Resent counts
Over
fl ow
Open and close the door and then
restore. If restoration is not possible,
restart.
12211 Internal error Network com-
munication CRC Error counts
Over-
fl ow
Open and close the door and then
restore. If restoration is not possible,
restart.
13000 Main control error H sync timeout No H-SYNC signal is received. Con-
fi rm H-sync signal . Con fi rm whether
the laser is ON. " 2.6.5 Checking H-
sync Signal, p.80"
13001 Main control error Polygon Timeout Con fi rm whether the laser is on. If so,
a polygon is abnormal.
13030 Main control error DMA Timeout Open and close the door and then
restore. If restoration is not possible,
restart.
13031
Main control error SCOM Timeout Open and close the door and then
restore. If restoration is not possible,
restart.
14000
Signal process error Gain Over fl ow The gain value has been incorrectly
set. Carry out
fi xed-current reading
and con fi rm the operation of the
ADB2. If the fi xed current is correct,
carry out a restart. If a problem is
identi
fi ed, replace the ADB2.
14001 Signal process error Gain Under fl ow The gain value has been incorrectly
set. Carry out
fi xed-current reading
and con fi rm the operation of the
ADB2. If the fi xed current is correct,
carry out a restart. If a problem is
identi
fi ed, replace the ADB2.
14002
Signal process error Offset Over fl ow The offset value has been incorrectly
set. Carry out
fi xed-current reading
and con fi rm the operation of the
ADB2. If the fi xed current is correct,
carry out a restart. If a problem is
identi
fi ed, replace the ADB2.
14003
Signal process error Offset Under fl ow The offset value has been incorrectly
set. Carry out
fi xed-current reading
and con fi rm the operation of the
ADB2. If the fi xed current is correct,
carry out a restart. If a problem is
identi
fi ed, replace the ADB2.
Code Medium Classifi-
cation Detailed Clas-
sification Countermeasures, etc.