Konica Minolta REGIUS 190, Service Manual

Page: 187 / 220

160
4.4 Error Code
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
04216
GoBackward receipt
time-out A GoBackward command (i.e.,
permission for erasure start after
reading) could not be received
from the SCB2 within 5 seconds
after the completion of subscan-
ning. Open the front door, remove any cas-
sette that may be present inside the
equipment, and then carry out a restart.
If this problem should reoccur, con
fi rm
that the SCB2(CN5)-MCB2(CN4) con-
nectors are connected and that cables
are not damaged or broken.
04217
Laser ON w/o send-
ing high voltage ON
(case 1) Even though a request for high
voltage On was not reported to
the SCB2, an attempt was made
to provide noti
fi cation of Laser On
to the SCB2 (with no stand-by
cassette in the insertion slot).
Open the front door, remove any cas-
sette that may be present inside the
equipment, and then carry out a restart.
04218
Laser ON w/o send-
ing high voltage ON
(case 2) Even though a request for high
voltage On was not reported to
the SCB2, an attempt was made
to provide noti
fi cation of Laser On
to the SCB2 (with a stand-by cas-
sette in the insertion slot).
Open the front door, remove any cas-
sette that may be present inside the
equipment, and then carry out a restart.
04219
Illegal command
received A command which was unrecog-
nizable to the MCB2 was received
from the SCB2. Open the front door, remove any cas-
sette that may be present inside the
equipment, and then carry out a restart.
If this problem should reoccur, con
fi rm
that the SCB2(CN5)-MCB2(CN4) con-
nectors are connected and that cables
are not damaged or broken.
Error
code Error name Error description Action