JUMO AQUIS touch P 202580, Operating Manual

Page: 136 / 322

10 Configuration
136
Response at hold inactive
active
hold Specification of the alarm state when the hold
function is activated, at calibration of the particu-
lar input or at error (overrange/underrange)
inactive: alarm suppressed
active: alarm forced
hold: alarm state is maintained regardless of
alarm condition changes
normal: alarm in acc. with alarm condition
Response at
calibration inactive
active
hold
normal
Response at error inactive
active
hold
Alarm type inactive
minimum alarm
maximum alarm
alarm window
invert alarm window Four alarm types (comparator functions) can be
selected to monitor measured values for violation
of limit values.
v
Characteristic lines after the table
only for
CR analysis inputs:
USP
Pre-alarm USP
purified water
Pre-alarm pur. water
Limit value alarms to USP <645> or
European Pharmacopoeia (Ph. Eur.) for
cleaned water
Alarm/Event list off
event
alarm Assignment of alarm notification to alarm list or
event list
Alarm text up to 21 text characters Text for the alarm/event list
Limit value -99999 to +99999 Limit value for the particular alarm type
Hysteresis 0 to 99999 Spacing between switch-on and switch-off points
for the alarm types
v
Characteristic lines after the table
Window range 0 to 99999 Range of the alarm window
v
Characteristic lines after the table
Pulse function Yes
No Time limit for alarm with the wiper time as maxi-
mum alarm duration
Pulse time 0 to 999 s Duration of alarm with pulse function activated
Alarm delay
On 0 to 999 s Time delay between occurrence of the alarm
condition and triggering of the alarm
Alarm delay Off 0 to 999 s Time delay between ending of the alarm condi-
tion and clearing of the alarm
Configuration point Selection/
setting option
Explanation