The User Manual of JAC200 Series General Frequency Converter
- 19 -
Chapter 5 Function Parameter List
FP-00 is set to nonzero value, that is to say, parameter protection password is set. Under function parameter
mode and user change parameter mode, input correct password, enter the parameter menu, cancel the
password and set FP-00 to 0.
The parameter menu is not protected by the password under the user customized parameter mode.
Group F and Group A are basic function parameters and Group U is monitoring function parameter.
The symbols in the function list are described as follows:
“
☆
” means that the set value of parameter can be changed when the frequency converter is stopped or in
running;
“
★
” means that the set value of parameter cannot be changed when the frequency converter is in running;
“●” means that the parameter value is actual test value and cannot be changed;
“*” means that the parameter is a “factory parameter”, can only be set by the manufacturer but can not be
operated by the user;
5.1 Basic function parameter list
Table 5-1 Basic function parameter list
Function
code
Name
Set range
Default
value
Chan
ge
F0 Basic function group
F0-01
Control mode of
Motor 1
0: No-speed sensor vector control (SVC)
2: V/F control
2
★
F0-02
Command source
selection
0: Command channel of operation panel
(LED OFF)
1: Command channel of the terminal (LED
ON)
2: Communication command channel (LED
flashes)
0
☆
F0-03
Selection of main
frequency source X
0: Digital setting (Preset frequency F0-08,
changeable UP/DOWN, no power-down
memory )
1: Digital setting (Preset frequency F0-08,
4
★
