DIGISPENSE 3020 CONTROLLER MODULE
Page 3-74
7 April, 2011
IVEK Corp.
P03L011B
Encoder Screen Description -
The Encoder screen displays encoder information and allows a user with Supervisor
permission to change the parameters. The current permission level determines which push-buttons are available as
shown.
The Start push-button is not functional, but the Stop push-button is functional while this screen is visible.
Status -
The status indicates the operational state of the system. Refer to section 3.3.9 for an explanation of each
status type.
Encoder -
The Encoder provides a feedback signal when the motor is operating. The setting can either be Disabled (if
no encoder option purchased on the Actuator Module) or Enabled (if encoder option purchased on the Actuator
Module).
Encoder Lines -
The number of encoder lines is based on the encoder installed on the Actuator Module. The range is
200 to 4000 with an increment value of 1.
To change a value;
1. Press the Arrow push-buttons to highlight the parameter.
2. Press the Enter push-button to bring up either the Select New Value or Enter New Value screen.
3. In the Select New Value screen use the up and down arrow push-buttons to select the value. In the Enter New
Value screen press the Minimum or Maximum push-buttons to select the desired value or use the left and right
arrow push-buttons to select the digit and the up and down arrow push-buttons to change the digit's value.
4. Press the Enter push-button.
