Intel M50FCP1UR, Manual

Page: 82 / 133

Intel® Server System M50FCP1UR System Integration and Service Guide
82
6. Squeeze the two hooks of the internal lock and pull it out (see Letter A).
7. Align the OCP adapter with the open OCP* bay slot and slide forward until the connectors make
secure contact (see Letter B).
8. Reinstall the internal lock with the lock orientation (see Letter C).
9. Reinstall the riser card assembly as needed (see Section 6.6 ).
10. Reinstall the system top cover (see Section 6.1.2 ).
6.10 M.2 Storage Device Replacement
The server board includes two M.2 connectors as shown in the following figure. Each M.2 connector supports
a PCIe* NVMe* or SATA SSD drive that conforms to a 22110 (110 mm) or 2280 (80 mm) form factor.
Required Tools and Supplies
•
Replacement M.2 SSD
• Anti-static wrist strap and conductive workbench pad (recommended)
•
Phillips* head screwdriver #1
Figure 113. M.2 SSD Removal
1. Power off the system and disconnect the system power cords.
2. Remove the system top cover (see Section 6.1.1 ).
3. If installed, remove the riser #1 assembly (see Section 6.6 ).
4. Locate the M.2 to be replaced.
5. Remove the screw to release the M.2 SSD from the server board (see Letter A).
6. Carefully lift the free end of the M.2 SSD and gently remove it from the connector in the direction
shown (see Letter B).
Figure 114. M.2 SSD Installation
7. Locate and carefully unpack the replacement M.2 SSD. Hold it by its edges.
8. Depending on the length of the M.2 SSD, use the onboard M.2 mounting stand-off at the appropriate
location.