Infineon TLE984 QX Series, User Manual

Page: 459 / 972

User Manual 459 Rev. 1.1
2019-03-18
TLE984xQX
Microcontroller with LIN and Power Switches for Automotive Applications
General Purpose Timer Units (GPT12)
T3EDGE 13 rwh Timer T3 Edge Detection Flag
The bit is set each time a count edge is detected. T3EDGE must be
cleared by software.
0
B
No count , No count edge was detected
1
B
Count , A count edge was detected
BPS1 12:11 rw GPT1 Block Prescaler Control
Select basic clock for block GPT1 (see also Section 16.3.5 )
00
B
8 , f
GPT
/8
01
B
4 , f
GPT
/4
10
B
32 , f
GPT
/32
11
B
16 , f
GPT
/16
T3OTL 10 rwh Timer T3 Overflow Toggle Latch
Toggles on each overflow/underflow of T3. Can be set or cleared by
software (see separate description)
T3OE 9 rw Overflow/Underflow Output Enable
0
B
Disabled , Alternate Output Function Disabled
1
B
T3OUT , State of T3 toggle latch is output on pin T3OUT
T3UDE 8 rw Timer T3 External Up/Down Enable
1)
0
B
T3UD , Count direction is controlled by bit T3UD;
input T3EUD is disconnected
1
B
T3EUD , Count direction is controlled by input T3EUD
T3UD 7 rw Timer T3 Up/Down Control
1)
0
B
Up , Timer T3 counts up
1
B
Down , Timer T3 counts down
T3R 6 rw Timer T3 Input Run Bit
0
B
Stop , Timer T3 stops
1
B
Run , Timer T3 runs
T3M 5:3 rw Timer T3 Input Mode Control
000
B
Timer Mode ,
001
B
Counter Mode ,
010
B
Gated low , Gated Timer Mode with gate active low
011
B
Gated high , Gated Timer Mode with gate active high
100
B
Reserved , Do not use this combination
101
B
Reserved , Do not use this combination
110
B
Incremental Interface Mode , (Rotation Detection Mode)
111
B
Incremental Interface Mode , (Edge Detection Mode)
T3I 2:0 rw Timer T3 Input Parameter Selection
Depends on the operating mode, see respective sections for
encoding:
Table 251 for Timer Mode and Gated Timer Mode
Table 252 for Counter Mode
Table 254 for Incremental Interface Mode
1) See Table 264 for encoding of bits T3UD and T3UDE.
Field Bits Type Description