IBM 7870B4U, Service Manual

Page: 95 / 268

7. Use a screwdriver to remove the four screws that secure the bezel assembly to
the blade server base assembly. Save the screws in a safe place. It is
recommended to use the same screws when installing the bezel assembly.
8.
While holding the bezel assembly and the blade server, rotate the blade server
so that the cover side is up.
9. Lift the bezel assembly away from the blade server.
10. If you are instructed to return the bezel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied
to you.
Installing the bezel assembly
Use this information to install a bezel assembly in the blade server.
Note:
1.
The following illustration shows how to install a bezel assembly in a blade
server.
2. The illustrations in this document might differ slightly from your hardware.
To install the bezel assembly, complete the following steps.
1.
If an optional expansion unit is installed, remove it (see “Removing an optional
expansion unit” on page 84).
2. If the control panel was removed, install it (see “Installing the control panel” on
page 83).
3. Orient the bezel with the front of the blade server, aligning the screw holes on
the bezel with the holes on the blade server.
Chapter 5. Removing and replacing blade server components
81