Configuring the 100/10 Ethernet Adapter
Configuring for Full-Duplex
If you have a hub that does not support auto-negotiation, manually
configure the adapter for full-duplex support. Configuration is
specific to the device driver that you are loading for your network
operating system. Refer to Table 1.
Note: You must set the adapter speed when configuring for
full-duplex support. Do not leave the speed set to
auto-negotiate.
Table 1. Setting Duplex Mode
Driver
How To Set Duplex Mode
Windows NT
Server 4.0
Define the Setup program:
1. Double-click on the Network icon on the Control Panel.
2. Click on the Adapters button.
3. Click on the Properties button.
4. Click on the Change button.
5. Under Network Speed, select 100 Mbps or 10 Mbps.
6. Under Duplex Mode, select Half Duplex or Full Duplex.
7. Click on Ok. Then, click on Ok again.
8. Click on Close.
9. Click on Ok to restart Windows NT Server Version 4.0.
Other Network
Operating
Systems
See the README file. To view the README files, insert
the Ethernet Configuration and Drivers diskette, and type
SETUP \README
at the DOS prompt. Then, press Enter.
Chapter 2. Configuring Your Server
39
