Configuring the 100/10 Ethernet Adapter
Depending on the hard disk capacity, the Low-Level Format
program could take up to two hours.
When To Use the Low-Level Format Program
Use the Low-Level Format program:
When you are installing software that requires a low-level
format
When you get recurring messages from the diagnostic tests
directing you to run the Low-Level Format program on the hard
disk
As a last resort before replacing a failing hard disk drive
Note: For information about backing up your files, see your
operating-system documentation.
Starting the Low-Level Format Program
Attention:
The Low-Level Format program erases all data and
programs.
1. If the hard disk is working, make a backup copy of all the files
and programs on the hard disk.
2. Select Format disk from the SCSISelect Disk Utilities menu;
then, follow the instructions on the screen.
Note: Hard disks normally contain more tracks than their stated
capacity (to allow for defective tracks). A message
appears on the screen if the defect limit is reached. If this
happens, have the system serviced.
Configuring the 100/10 Ethernet Adapter
Some PC Server 315 models come with an Ethernet adapter
preinstalled as a standard feature. The adapter contains three LEDs
lights visible from the back of the server that indicate the status of
the connection, monitor read and write activity, and indicate a 100
Mbps connection. Refer to “Troubleshooting the 100/10 PCI
Ethernet Adapter” on page 168 for more information about the
LEDs.
Chapter 2. Configuring Your Server
35
