Security Options
1. Locate the password jumper (PWD) in the system-board
illustration in “Locating System-Board Components” on
page 51. The jumper settings are shown in the following
illustration.
Normal
Erase
3
2
1
3
2
1
You might have to remove server components (such as adapters
or the riser card) to gain access to the jumper.
2. Change the jumper's position:
a. Lift the jumper straight off the pin block.
b. Align the holes in the bottom of the jumper with the center
pin and the pin that was not covered previously.
c. Slide the jumper over these pins.
This procedure removes the password.
Chapter 3. Installing Options
109
