Configuring the 100/10 Ethernet Adapter
If a message appears stating The system has not enabled
busmastering on the device you are installing, the device driver will
attempt to enable mastering when it loads. Run the adapter
diagnostics to see if busmastering is allowed in the slot selected.
5. Click on Test.
Notes:
When testing a newly configured adapter, the network
device driver will not be active. The diagnostic will test
only the adapter and its connection to the network.
When testing a previously configured adapter, the network
device driver will be active. The diagnostic will test the
adapter, its connection to the network, and the device
driver. The test will also track the actual network activity of
the device driver.
6. When testing completes, click on OK to accept the
configuration. Then, click on OK again.
7. Under Network Adapter, select the IBM 100/10 PCI Ethernet
Adapter. Then, click on Close.
Note:
If you have other LAN protocols installed, such as TCP/IP,
additional screens will appear requesting configuration
information. If this occurs, follow the instructions on the screen.
8. Remove the Ethernet Configuration and Driver diskette from
drive A.
9. Click on Yes in the Network Settings dialog box to restart
Windows NT Server Version 4.0.
Troubleshooting
Make sure that you are using the device drivers that come with
this adapter.
Make sure that the device driver is loaded and the protocols are
bound. See the Network Bindings dialog box in Windows NT
Server 4.0 to verify this.
Chapter 2. Configuring Your Server
37
