IACDRIVE I5300 Series, User Manual, Page: 200 / 272

Description of Function Codes
I5300 User Manual
- 200 -
Figure 6-25 Diagram of the overcurrent stall protection function
Output
current
Output
frequency
(Hz)
Set
frequency
Overcurrent stall
protective current
Time (t)
Time (t)
Acceleration
process
Deceleration
process
Constant-
speed process
F unction Code Parameter Name Setting Range Default
P 9-07
Short-circuit to ground upon power-
on
0: Disabled
1: Enabled
1
It is used to determine whether to check the motor is short-circuited to ground at power-on
of the AC drive. If this function is enabled, the AC drive's UVW will have voltage output a
while after power-on.
F unction Code Parameter Name Setting Range Default
P 9-09 F ault auto reset times 0–20 0
It is used to set the times of fault auto resets if this function is used. After the value is
exceeded, the AC drive will remain in the fault state.
F unction Code Parameter Name Setting Range Default
P 9-10 DO action during fault auto reset
0: Not act
1: Act
0
It is used to decide whether the DO acts during the fault auto reset if the fault auto reset
function is selected.
F unction Code Parameter Name Setting Range Default
P 9-11 Time interval of fault auto reset 0.1s–100.0s 1.0s
It is used to set the waiting time from the alarm of the AC drive to fault auto reset.