Honeywell Rapid Eye, Administrator'S Manual

Page: 225 / 294

Rapid Eye Multi-Media DVR System Administrator Guide
Document 800-02953V4 Rev A 225
03/10
Microsoft Windows
To send alarms over a dial-up connection, you will need to obtain a point-to-point protocol
(PPP) username and password for the PC used as an alarm station, or for its RAS server,
from their Microsoft Windows operating system. See
Point-to-Point Protocol (PPP) Fields in
an Alarm Station’s Definition on page 220 .
Setting Up a Dial-Up Connection to an Alarm Station
1. Add or update an alarm station definition (as explained in Adding an Alarm Station
Name and Reports , page 218 ). The IP Address field is left empty for a dial-up
connection to an alarm station, except if a remote access service (RAS) server—apart
from the alarm station—is part of the connection. For RAS servers, see
RAS
Connection to an Alarm Station on page 231 .
2. Select the Use Dial-up Networking option.
3. Leave the Country Code as
(dialing same country)
, unless the Multi-Media
unit is in a different country than the alarm station.
Caution Honeywell recommends using the (dialing same country) option.
Do not use your country’s name, such as United States of America (1),
unless the alarm station is in a different country from the Multi-Media unit.
Figure 11-6 Area Code Needed to Connect to a Multi-Media Alarm Station
4. Enter the alarm station’s area code in the Area Code (City Code) field.
5. Enter the alarm station’s telephone number in the Phone Number field.