Honeywell Rapid Eye, Administrator'S Manual

Page: 109 / 294

Rapid Eye Multi-Media DVR System Administrator Guide
Document 800-02953V4 Rev A 109
03/10
Privacy Zones for RapidDome
Figure 6-14 Setting Up a Privacy Zone on a RapidDome PTZ Camera
Display of the video feeds for PTZ presets 100 to 127 can be toggled on and off. When the
dome is at the preset’s position and zoom value, and that preset is enabled, video will not
be displayed for that Privacy Zone.
Press Reset All to cancel the privacy applied to your presets. A confirmation dialog box
appears. Click Yes.
Setting a Privacy Zone
Select the box next to the preset name so that it shows a check-mark. See Figure 6-14 ,
above. Remove the checkmark to view Live and recoded video from that PTZ preset.
Using ACUIX Domes
An ACUIX™ PTZ dome with Intellibus™ protocol can be configured using Rapid Eye View
software. In preparation, installers should:
• Set each ACUIX dome to Intellibus mode (IBus).
• Set DIP switches 5-8 to ON for each ACUIX dome. The Camera Address can then be
set using rotary switches SW1 to SW4 on the PCB at the base of the dome.
• Connect the domes to a port on the Rapid Eye unit.
• Notify the Multi SA of the number of the port used on the Rapid Eye unit and the
Camera Address used for each ACUIX dome.
Configuring the Intellibus Device for a Rapid Eye Unit
1. Assign the Intellibus device to the port used by the installers, by dragging its icon
from the Unassigned Devices to the Port used by the installers.
Figure 6-15 shows the
result when Port 4 is being used.
• Ports 3 through 10: Select RS-485 on the Serial Devices tab.
• Ports 1 or 2: Select RS-232 on the Serial Devices tab. Use a hardware converter
for RS-232/RS-485 on these ports to translate communications to and from the
ACUIX domes.