HEIDENHAIN TNC 620, User Manual

Page: 36 / 521

Basic information | Control model, software and features
1
The control can execute NC programs with the
SECTION
MONITORING
NC function. This NC function may be included in
NC programs of the TNC7, but has no function on the TNC 620.
You can define a pallet counter on the control. This allows you to
define a variable number of parts produced, for example during
pallet machining with automatic workpiece change. For this
purpose, the
TARGET
and
COUNT
columns have been added to
the pallet table (option 22).
Further information: "Application", Page 318
The
TRANS
tab of the additional status display indicates the
active shift in the working plane coordinate system (
WPL CS
). If
the shift comes from a compensation table (
*.wco
), the control
shows the path to the compensation table as well as the number
and, if applicable, the comment of the active row.
Further information: "Additional status displays", Page 71
The TS 760 input option has been added to the
TYPE
column of
the touch probe table.
Further information: "Touch probe table", Page 148
The
POS. DISP.
soft key enables you to switch the tool table
view. The control displays the tool table in combination with the
position display or in full-screen mode.
Further information: "Tool table fundamentals", Page 130
The control supports the TS 760 workpiece touch probe.
Further information: "3-D touch probes (option 17)", Page 124
36
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022