HEIDENHAIN TNC 620, User Manual

Page: 222 / 521

Setup | Compensating workpiece misalignment with 3-D touch probe (option 17)
5
Operating and programming notes:
Select the probe direction perpendicular to the
angle reference axis when measuring workpiece
misalignment.
To ensure that the basic rotation is calculated
correctly during program run, program both
coordinates of the working plane in the first
positioning block.
You can also use a basic rotation in conjunction with
the
PLANE
function (except for
PLANE AXIAL
). In
this case first activate the basic rotation and then the
PLANE
function.
You can also activate a basic rotation or offset
without probing a workpiece. To do so, enter a
value in the corresponding input field and press the
SET BASIC ROTATION
or
SET TABLE ROTATION
soft
key.
The behavior of the control during presetting depends
on the setting in the
chkTiltingAxes
machine
parameter (no. 204601).
Further information: "Introduction", Page 204
222
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022