HEIDENHAIN TNC 620, User Manual

Page: 351 / 521

MOD functions | Changing the machine settings
9.9 Changing the machine settings
Selecting the kinematics
Refer to your machine manual.
The
Kinematics
function will be configured and enabled
by your machine tool builder.
NOTICE
Danger of collision!
All stored kinematics can also be selected as active machine
kinematics. By this means, all manual movements and machining
operations are executed using the selected kinematics. All
subsequent axis movements pose a risk of collision!
Use the
Kinematics
function exclusively in the
Test Run
operating mode
Use the
Kinematics
function for selecting the active machine
kinematics only if required
The
Kinematics
MOD function in the
Machine settings
group allows
you to select different kinematics as machine kinematics for the
test run. You can use this function to test NC programs whose
kinematics does not match the active machine kinematics.
The various kinematics must be defined and enabled by the machine
tool builder. When you select a kinematics for the test run, the
machine kinematics remains unaffected.
To change the kinematics, proceed as follows:
Select the
Machine settings
group in the MOD menu
Select the
Kinematics
function
Select the desired kinematics for the
SIM
channel
Press the
APPLY
soft key
Press the
OK
soft key
The control saves the selected kinematics for the
Test Run
operating mode.
Ensure that you have selected the correct kinematics
in the Test Run operating mode for checking your
workpiece.
9
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
351