HEIDENHAIN TNC 620, User Manual

Page: 164 / 521

Tools | Tool carrier management
4
Assigning a tool carrier
To allow the control to factor a tool carrier into calculations, you
must assign the tool carrier to a tool and call the tool again .
Parameterized tool carriers can consist of several
subfiles. If the subfiles are incomplete, the control will
display an error message.
Only use fully parameterized tool carriers, error-free
STL files or M3D files.
Tool carriers in STL format must meet the following
requirements:
Max. 20 000 triangles
Triangular mesh forms a closed shell
If an STL file does not meet the requirements of the
control, then the control issues an error message.
To assign a tool carrier to a tool, proceed as follows:
Operating mode: Press the
Manual operation
key
Press the
TOOL TABLE
soft key
Press the
EDIT
soft key
Move the cursor to the
KINEMATIC
column of the
required tool
Press the
SELECT
soft key
The control opens a pop-up window with the
available tool carriers.
Select the desired tool carrier using the preview
Press the
OK
soft key
The control copies the name of the selected tool
carrier to the
KINEMATIC
column.
Exit the tool table
164
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022