HEIDENHAIN TNC 620, User Manual

Page: 140 / 521

Tools | Tool data
4
Proceed as follows:
Save the tool table of the iTNC 530 to the
TNC:\table
directory
Select the
Programming
operating mode
Press the
PGM MGT
key
Move the cursor to the tool table you want to
import
Press the
MORE FUNCTIONS
soft key
Press the
ADAPT NC PGM / TABLE
soft key
The control asks you whether you want to
overwrite the selected tool table.
Press the
CANCEL
soft key
Alternative: Press the
OK
soft key to overwrite
Open the converted table and check its contents
New columns in the tool table are highlighted
green.
Press the
REMOVE UPDATE INFO
soft key
The green columns are displayed in white again.
The following characters are permitted in the
Name
column of the tool table: # $ % & , - . 0 1 2 3 4 5 6 7 8 9 @
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z _
During the import, commas will be converted to periods.
The control overwrites the active tool table when
importing an external table with the same name. To
prevent data loss, back up the original tool table before
you start the import!
The procedure for copying tool tables using the file
manager is described in the section on file management.
Further information: User's Manual for Klartext
Programming or ISO Programming
When iTNC 530 tool tables are imported, all defined tool
types are imported as well. Tool types not present are
imported as type
Undefined
. Check the tool table after
the import.
140
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022