HEIDENHAIN GAGE-CHEK 2000, Operating Instructions Manual

Page: 197 / 250

Information for the Operator user |
Contents of chapters in the "Information for the Operator user" part
The table below shows:
The chapters included in this "Information for the Operator user" part
The information contained in these chapters
The target groups that these chapters are mainly intended for
Section Contents
Target
group
This chapter contains information about…
OEM Setup Operator
1 "Preparing a measure-
ment"
... the preparation of a measurement ✓ ✓
2 "Preset"
... the creation of a preset table
... the selection of presets
✓ ✓
3 "Lengths and angles" ... the reading of measured values ✓ ✓
5 "Probing functions"
... the configuration of the function element
... the performance of a measurement
✓ ✓
6 "Minimum, maximum,
and range"
... the configuration of the function element
... the performance of a measurement
✓ ✓
7 "Diameter/Radius"
... the configuration of the function element
... the performance of a measurement
✓ ✓
8 "Relative measurement"
... the configuration of the function element
... the performance of a measurement
✓ ✓
9 "Mastering"
... the configuration of the function element
... the performance of a measurement
✓ ✓
10 "Dial gage"
... the configuration of the function element
... the performance of a measurement
✓ ✓
11 "Management of parts"
... the configuration of the function element
... the performance of a measurement
✓ ✓
12 "Sending measured
values to a computer"
... the transmission of measured values to a computer
(measured value output)
✓ ✓
14 "What to do if ..."
... causes of faults or malfunctions of the product
... corrective actions for faults or malfunctions of the
product
✓ ✓ ✓
III
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 06/2022
197