HEIDENHAIN GAGE-CHEK 2000, Operating Instructions Manual

Page: 113 / 250

Information for OEM and Setup users | Commissioning
Acquire the actual values manually
Settings
►
Axes
►
General settings
►
Error compensation
►
Nonlinear error compensation (NLEC)
Tap
Table of supporting points
Enter the actual values of the supporting points
Confirm each entry with
RET
Activating the nonlinear error compensation
Settings
►
Axes
►
General settings
►
Error compensation
►
Nonlinear error compensation (NLEC)
Activate
Compensation
with the
ON/OFF
slide switch
The error compensation is applied from the next measurement
Configuring
Squareness error compensation (SEC)
Squareness error compensation (SEC)
enables angular errors to be compensated
during measuring point acquisition. The compensation factor is determined by
comparing the deviation of the actual measurement result from the nominal angle of
the spatial axes. The compensation factor is applied to the entire measuring range.
Settings
►
Axes
►
General settings
►
Error compensation
►
Squareness error compensation (SEC)
Parameter Explanation
XY plane
XZ Plane
YZ plane
Mechanical influences on the squareness of the axes relative to
each other are compensated
Setting range:
85° ... 95°
Default value:
90
The measured values (M) and nominal values (S) of the three spatial axes are
displayed
Enter the measured values of the reference standard (= nominal values)
Activate
Compensation
with the
ON/OFF
slide switch
Squareness error compensation is applied from the next measurement
II
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 06/2022
113