HEIDENHAIN 548431-05, User Manual, Page: 457 / 722

ICP programming | Contour elements – turning contour
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
457
Undercut form U
Programming an undercut form U:
Select the form elements
Select
Undercut form U
Enter the undercut parameters
Parameters:
I : Undercut depth
K : Length
R
:
Undercut radius
P : Chamf./round.
U
,
F
,
D
,
DF
:
Further information: "Machining attributes", Page 418
ICP generates a G25 in smart.Turn mode of operation.
Undercuts can be programmed only between two linear
elements. One of the two linear elements must be
parallel to the X axis.
Undercut form H
Programming an undercut form H:
Select the form elements
Select
Undercut form H
Enter the undercut parameters
Parameters:
K : Length
R
:
Undercut radius
W : Plunging angle
U , F , D , DF :
Further information: "Machining attributes", Page 418
ICP
generates a
G25
in
smart.Turn
mode of operation.
Undercuts can be programmed only between two linear
elements. One of the two linear elements must be
parallel to the X axis.