HEIDENHAIN 548431-05, User Manual, Page: 418 / 722

ICP programming |
ICP contours
6
418
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Machining attributes
You can assign the following machining attributes to the contour
elements.
Machining attributes:
U : Oversz additive to other oversizes
ICP generates a G52 Pxx H1 .
F : Feed per rot. – (special feed rate for finishing)
ICP generates a G95 Fxx .
D : Corr. additiv – Number of the additive D compensation for
the finishing operation, e.g. D = 01 to 16
ICP
generates a
G149 D9xx
.
FP : Do not machine the element (only necessary for
TURN PLUS )
0: No
1: Yes
IC
:
Measuring cut oversize
(not available in
Teach-in
submode)
KC : Length of measuring cut (not available in Teach-in
submode)
HC : Measuring cut counter – number of workpieces after which
a measurement is performed
The machining attributes are effective only for the
element in which the attributes have been entered in
ICP .
Calculation of contour geometry
The control automatically calculates all missing coordinates,
points of intersection, center points, etc. that can be derived
mathematically.
If the entered data permit several mathematically possible
solutions, you can inspect the individual solutions and select the
proposal that matches the drawing.
Each unresolved contour element is represented by a small
symbol below the graphic window. The control displays all contour
elements that can be drawn, even if they are not yet fully defined.