HEIDENHAIN 548431-05, User Manual, Page: 46 / 722

Introduction and fundamentals | Features
1
46
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
1.3 Features
Configuration
Basic version: X and Z axis, spindle
Positionable spindle and driven tool
C axis and driven tool
Y axis and driven tool
B axis for machining in a tilted plane
Digital current and speed control
Modes of operation
Machine
mode of operation
Manual slide movement through axis-direction keys or electronic
handwheels.
Graphic support for entering and running Teach-in cycles without
saving the machining steps in alternation with manual machine
operation.
Thread reworking (thread repair in a second workpiece setup).
Teach-in
submode
Sequential linking of Teach-in cycles, where each cycle is
run immediately after input, or is graphically simulated and
subsequently saved.
Program run
submode
All are possible in single-block and full-sequence modes:
DINplus programs
smart.Turn programs
Teach-in programs
Setup functions in the
Machine
mode of operation
Setting the workpiece datum
Defining the tool change point
Defining the protection zone
Tool measurement through touch-off, touch probe or optical
gauge