HEIDENHAIN 548431-05, User Manual, Page: 44 / 722

Introduction and fundamentals | Configuration
1
44
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
C axis
With a C axis you can drill and mill a workpiece on its face and
lateral surfaces.
When the C axis is used, one axis interpolates linearly or circularly
with the spindle in the given working plane, while the third axis
interpolates linearly.
The control supports part program creation with the C axis in:
Teach-in submode
smart.Turn
mode of operation
DINplus programming
Y axis
With a Y axis you can drill and mill a workpiece on its face and
lateral surfaces.
During use of the Y axis, two axes interpolate linearly or circularly
in the given working plane, while the third axis interpolates linearly.
This enables you to machine slots or pockets, for example, with
plane floors and perpendicular edges. By defining the spindle
angle, you can determine the position of the milling contour on the
workpiece.
The control supports part program creation with the Y axis in:
Teach-in submode
smart.Turn
mode of operation
DINplus programming