HEIDENHAIN 548431-05, User Manual, Page: 233 / 722

Teach-in | Turning cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
233
Cycle run:
1 Calculate the proportioning of cuts (infeed), taking the
Workpiece blank oversize J and the Type of cut lines H into
account
J
= 0: The cutting geometry is taken into account. This may
result in the use of different infeeds for the longitudinal and
transverse directions
J > 0: The same infeed is used for both the longitudinal and
the transverse direction
2 Approach the workpiece from the Start point on a paraxial path
for the first pass
3 Machine the workpiece according to the calculated
proportioning of cuts
4 Return and approach for the next pass
5 Repeat 3 to 4 until the defined area has been machined
6 Return to the
Start point on a paraxial path
7 Move to the
Tool change point
according to the setting in
G14