HEIDENHAIN 548431-05, User Manual, Page: 493 / 722

ICP programming | Lateral surface contours in
smart.Turn
mode of operation
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
493
Linear pattern on lateral surface
Reference data of lateral surface:
ID
:
Contour
PT : Milling depth
XR : Reference diameter
Parameters of figure:
Z
:
1st pattern point
CY : 1st pattern point as linear dimension (reference: diameter
XR
)
C : 1st pattern point (angle)
QP : Quantity of points in pattern
ZE
:
Final point
of pattern
ZEi : Final point – Distance between two pattern points (in Z )
WP : Final point of pattern (angle)
WPi
:
Final point
– Distance between two pattern points (angle)
AP : Position angle
RP
:
Length
– Total length of pattern
RPi : Length – Distance between two pattern points
Parameters of the selected figure/hole
You can use the Select reference plane function to determine the
Reference diameter XR
.
Further information: "Reference data and nested contours",
Page 472
ICP generates the following:
The LATERAL section code with the Reference diameter
parameter. In nested contours,
ICP
generates only one section
code
a
G308 with the Contour name and Milling depth or Boring
depth
(–1*
BT
) parameters
A G411 with the parameters of the pattern
The
G
code and the parameters of the figure or hole
A G309