HEIDENHAIN 548431-05, User Manual, Page: 100 / 722

Machine mode of operation | Machine data
4
100
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Machine with counter spindle
You have to select a workpiece spindle depending on the machine.
If your machine is equipped with a counter spindle, the
WP
parameter is shown in the
TSF
dialog.
Cycle parameters:
WP
:
No. of spindle
(machine-dependent)
The WP parameter allows you to select the workpiece spindle
for machining in
Teach-in
submode and with the MDI cycles of
Machine mode of operation.
Select the workpiece spindle for machining with
WP
:
Main drive
Counter spindle for rear-face machining
The
WP
parameter setting is saved in the Teach-in and MDI cycles
and displayed in the corresponding cycle form.
If you selected the counter spindle for rear-face machining with the
WP parameter, the cycle is mirrored (in the opposite Z direction).
Use tools with suitable tool orientation.
In the TSF menu, the setting for the WP parameter is
changed when you:
Run a cycle with another
WP
parameter setting
Select a program in Program run submode