HEIDENHAIN 548431-05, User Manual, Page: 610 / 722

Organization mode of operation | Parameters
9
610
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
General settings
Measuring range (604603)
[mm]: The touch probe must be deflected within the measuring range. Otherwise, an
error message will be issued
System
Settings for Machine mode of operation (604900)
Save cycle without simulation (604903)
TRUE: The cycle can be saved without previous simulation or execution
FALSE: The cycle can only be saved after previous simulation or execution
Executed tool change with NC start (604904)
TRUE: A tool change using the TSF dialog will be executed with the Start cycle
FALSE: No tool change will not be executed with the Start cycle
Separate dialogs for tool change, spindle speed and feed rate (TSF) (604906)
TRUE: Input of tool change, spindle speed, and feed rate data in separate dialogs
FALSE: Input of all cutting data in the TSF dialog
System
Settings for load monitoring (124700)
Activate load monitoring (124701)
TRUE: Load monitoring is active
FALSE: Load monitoring is inactive
Factor for utilization limit-1 (124702)
[%]: This value, multiplied by the reference value determined during reference
machining, is the load utilization limit-1
Factor for utilization limit -2 (124703)
[%]: This value, multiplied by the reference value determined during reference
machining, is the utilization limit-2
Factor for the limit of the utilization sum (124704)
[%]: This value, multiplied by the reference value determined during reference
machining, is the limit value of the utilization sum
Channel settings
Channels
CH_NC1
Configuration of the machining cycles (201000)
Suppress "Residual material due to cutting edge geometry" warning (201010)
On: No warning is displayed
Off: A warning is displayed
Settings for the simulation
Simulation